S2Konnect N-2020T Manual do Utilizador descarregar pdf (Página 10)

S2Konnect N-2020T

3. At the other end of the cable connect the connector to the port on the network device.

The port type (e.g. 1000Base-T) on the network device and that in the S2Konnect

Network Card must be identical.

4. Reconnect the Switch and other units to the power supply.

5. Turn on the network device and the Switch or other station.

6. Check the SPD/LNK/ACT LED belonging to the port you plugged in the plug to nd out if

the cable is connected correctly.

If the LED is on, the connection is established and active. Otherwise you have to check

the S2Konnect units more closely (for details, refer to section “LED Displays” on p. 19).

Hardware Features

The S2Konnect N-2020T 10/100/1000Base-T Network Interface Card are designed for easy ins-

tallation and high performance in environments with varying trafc loads and multiple users.

The network cards can be connected to different equipment in the network.

Connections maybe done with different backgrounds, such as aggregation connections to get a

higher throughput, establish redundant connections for failover or connect the cards with each

ports to different networks for routing or inspection purposes.

Connection options:

1. Redundancy (Redundant Link Management Technology)

One port is active and all trac is going through that port, a second port is active but

without trafc.

If active port is disconnected or any infrastructure (cable, switch...) that is between the

adapter an network is damaged the other port will take over.

(please refer to Redundant Link Management Technology installation on the software

readme le).

2. Link Aggregation

LAN

Figure 2. Picture RLMT

Figure 3. Picture Aggregation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sem comentários

S2Konnect N-2020T Manual do Utilizador Página 10